Reflow Split Die
The CT Split Die machine differs from the CT Reflow Chamber machine because of its ability to be programmed to skip over various parts of a catheter assembly, therefore removing heat from designated parts of the catheter.
Description
The CT Split Die uses a split die design that opens and closes around the needed parts where heat is necessary. This is especially advantageous should a catheter assembly have sensitive sensors or other materials in it where heat should not be applied. Additional features can be added to the Split Die Chamber including Operator safety precautions, Ease conversion to CT STRETCHER, and Loading elevators for operators to load assemblies at lower levels.
Specifications
- Chamber Options:
- 8 or 10 Chambers
- Height Options:
- 89″, 100″, 108″, 120″, 144″
- 5″ Chamber length (STD size)
- Chambers interchangeable – hot or cold
- 2 pins per screw
- Per changeover (less than 10 mins)
- Low maintenance required
- Crated weight 900-1000 lbs (STD)
- Clam shell 1200 lbs. 3 phase
- 208-240 VAC 30 AMP
- Air pressure – minimum 90 PSI
- Easy setup
Options
- High Temp Package
- Loading Elevator
- Light Curtain
- Safety Pull Cord
- Door Interlock
- Replacement PTFE
- Replacement Chambers:
- .200 – .375 Dia
- .187 Dia
- .376 – .500 Dia
- .125 Dia
